Advertisement

Canon C300 Mark III Lab Test (Pre-Production): Dynamic Range, Rolling Shutter and Latitude

Canon C300 Mark III Lab Test (Pre-Production): Dynamic Range, Rolling Shutter and Latitude

Shortly after the publication of our Canon C500 Mark II lab test last week, we learned that we will gain early access to a pre-production Canon C300 Mark III in our headquarters in Vienna. And of course we had to take an immediate “lab test” look at Canon’s latest Super 35 addition to their line of cinema cameras.

After 5 weeks of home office, leaving my space mainly for only a quick walk with the dog and food shopping, I had to jump at this chance. So I picked up my face mask, greeted Nino from a safe distance and after a quick coffee together (and washing our hands thereafter) we headed straight into this.

Please note that Canon mentioned this to be a pre-production unit, the firmware used was 1.8.1.1 – the final image may change when the camera is released. Nevertheless, we were super interested in getting a lab benchmark for this new camera so here we go!

Time was very limited, which is not the best precondition for a thorough lab test. However, as we just ran the C500 Mark II through the lab (see our article here) and we quickly saw that the C300 Mark III shares the body, menu structure and a lot of other features including codecs with the C500 Mark II, we were fast in setting up the cam and decided to focus on 10bit XF-AVC, 4K DCI image acquisition for now (internal raw recording mode is available as well).

Canon claims in their press release that this new Super 35 sensor in the C300 Mark III uses a dual gain circuit to capture increased highlight and shadow detail, which should translate into a very good dynamic range.

Dynamic Range of the Canon C300 Mark III at ISO800

As there was no specific information on the native ISO which should yield the best dynamic range results, we choose ISO800 to run our tests. As mentioned above, the 10bit internal all – I XF-AVC codec with Canon Log2 / C.Gamut (color matrix “neutral”, noise reduction “off”) at a resolution of 4096×2160 at 25 frames per second was used.

Canon claims their dual gain architecture to be active from 24 – 60 frames per second, therefore we tested 25, 60, 75 and 120 frames per second.

And here is the result for 25 -60 fps, see figure 1 below: a strong 12.8 stops at a signal to noise ratio of 2 is calculated. This dynamic range result is the same for 60 frames per second –  a really good result for a Super 35 sensor. For comparison, the BMPCC6K shows 11.9 stops in our tests, the FUJIFILM X-T3 11.2 stops.

Fig. 1: IMATEST dynamic range results for the Canon C300 Mark III at 25fps, ISO 800, CLOG2 / C.Gamut, 4K DCI. Very strong 12.8 stops at a signal to noise ratio of 2 are calculated.

The waveform plot of the Xyla 21 chart confirms this result, see figure 2 below:

Fig. 2: Waveform plot of the Xyla 21 stepchart for the Canon C300 Mark III at 25fps, ISO 800, CLOG2 / C.Gamut, 4K DCI. About 13 stops can be identified above the noise floor.

At 75 frames per second (4K DCI) the situation changes, as the dual gain architecture of the sensor is no longer active. This can be seen in the waveform plot in figure 3 below – the image becomes much noisier, and around 12 stops can be identified above the increased noise floor:

Fig. 3: Waveform plot of the Xyla 21 stepchart for the Canon C300 Mark III at 75fps, ISO 800, CLOG2 / C.Gamut, 4K DCI. The dual gain architecture is no longer active – about 12 stops can be identified above the noise floor.

IMATEST confirms this and calculates 11.6 stops (at a signal to noise ratio of 2, medium value in the graph below) – still, a very good result!

Fig. 4: Waveform plot of the Xyla 21 stepchart for the Canon C300 Mark III at 75fps, ISO 800, CLOG2 / C.Gamut, 4K DCI. The dual gain architecture is no longer active – 11.6 stops are calculated.

Rolling Shutter of the Canon C300 Mark III

As mentioned previously, we are using a strobe light at 300 Hz to calculate rolling shutter of CMOS sensors.

First interesting result – at 25 fps and up to 60 fps 15.6 ms rolling shutter are measured, see figure 5 below:

Fig. 5: at 25 frames per second up to 60 frames per second the rolling shutter in 4K DCI mode is 15.6 ms

This is a good but not outstanding value for the rolling shutter – other Super35 cameras like the FUJIFILM X-T3 are on the same level, the aforementioned BMPCC6K has 19.8ms.

Now, this camera also offers up to 120 frames per second in 4096×2160 – now how does this work? 15.6ms rolling shutter would not support higher frame rates than 60 fps.

Obviously, by eliminating the dual gain read out at 75fps and higher, the rolling shutter drops to 7.7ms, see figure 6:

Fig. 6: at 75fps up to 120 frames per second the rolling shutter in 4K DCI mode is 7.7 ms, as the dual gain readout is no longer active at these frame rates

Latitude (underexposure) Test of the Canon C300 Mark III at ISO800

As mentioned earlier, “latitude” is the capability of a camera to retain details and colors when over- or underexposed and pushed back to zero exposure.

In our Lab scene, the zero exposure level represents a base exposure of F4 at ISO800, shutter angle 360° for 25fps DCI 4K. The exposure level is checked by the waveform reading of my colleague Nino’s face which shows a maximum of 60% Luma value, the white sheet of paper comes in at 65%.

Then, exposure is dropped successively to 180°, 90°, 45°, 22.5° and finally 11.25° shutter angle – 5 stops underexposed. The resulting images are pushed back to the zero exposure level in postproduction using DaVinci Resolve Studio.

The good dynamic range results are giving already a strong indication that this test will go well with the C300 Mark III – spoiler alert!

Let’s have a look first at the zero exposure level:

Fig. 7: zero / base exposure level (graded) for the studio scene with the C300 Mark III at 25fps, 360° shutter angle F4

Let’s jump right ahead and have a look at the 3 stops underexposed image, figure 8 below:

Fig. 8: 3 stops underexposed and pushed back – the C300 Mark III at 25fps, 45° shutter angle F4

Not much to see in figure 8 above, right? The C300 Mark III behaves very well at this exposure level. The image becomes a bit grayish, and some red speckles of noise start to appear (look at the shadow area below Nino’s cheek). Those speckles can be easily removed by just a bit of temporal noise reduction in post.

Fig. 9: 4 stops underexposed and pushed back – the C300 Mark III at ISO800, 25fps, 22.5° shutter angle F4

A similar observation holds true for 4 stops of underexposure pushed back – figure 9: the noise in the shadows increases but can be removed quite effectively by just a bit temporal noise reduction. The noise is finely dispersed, like film grain, which looks really good (and is easily removed by noise reduction).

Fig. 10: 5 stops underexposed and pushed back – the C300 Mark III at 25fps, 11.25° shutter angle F4

Finally, at 5 stops underexposure, the noise becomes a bit nasty. You can remove this noise again quite effectively in post by adding temporal noise reduction (still no spatial NR needed), but the shadow areas nevertheless have those strong reddish noise speckles, which become posterized areas of red after noise reduction.

But I would say you could still get away with this image, as it does not show those fixed horizontal/vertical lines like all other cameras tested so far –  which are very distracting in a moving image and cannot be removed easily in post.

Here is an example of using 3 frames temporal noise reduction in DaVinci Resolve, 15 temporal threshold (no spatial NR), see figure 11 below:

Fig. 11: 5 stops underexposed and pushed back – the C300 Mark III at ISO800, 25fps, 11.25° shutter angle F4 using noise reduction in DaVinci Resolve (3 frames temporal, 15 threshold, no spatial)

Summary

This year Canon surprises us all with their innovative new cameras – the C500 Mark II full-frame camera from late last year already set the benchmark in our lab for a full-frame sensor, and the Super 35 sensor sized C300 Mark III is almost on the same level – a superb lab result, leaving behind all other cameras in this sensor class – with the exception of the ARRI Alexa of course.

Hence, overall a third place behind the C500 Mark II and the ARRI Alexa. Well done, Canon!

What do you think about the new Canon C300 Mark III, do you think it will gain its firm place in the production world after the world opens up for business again? Let us know in the comments below. 

57 Comments

Subscribe
Notify of

Filter:
all
Sort by:
latest
Filter:
all
Sort by:
latest

Take part in the CineD community experience